Example of such solutions are OpenVPN or Wireguard. In this blog post we will deploy openVPN as a tenant admin to allow access cloud resources from Cloud using VPN Client.
DNAT rule to allow OpenVPN appliance Inbound access from Internet.OpenVPN Appliance IP to one External IP.SNAT rule to allow OpenVPN appliance out bound Internet access.check the summary and click finish to create a network a routed netwrokĪfter creating routed network, go on to Edge gateway and open the edge gateway configuration:Ĭreate two NAT rules for OpenVPN appliance.Create a pool of IPs for Network to allocate.Choose appropriate Edge for this routed network association.In Cloud Director go to Networking Section and Click on New to create a new router Network.Lets create a new routed Org VDC Network and we will deploy OpenVPN on this network, you can also deploy it on existing routed network. I have downloaded the latest OpenVPN appliance from Here.Since Cloud Director Service is managed service and its architecture is different then cloud providers environment, so for CDS, we need to follow few extra steps as explained below: Deploy OpenVPN Appliance You might have to open certain firewall rules to access OpenVPN admin console which depend on from where you are accessing the console. assign a valid IP Manually from the range which we had created during network creation, if you are not putting IP here then on appliance you need to struggle for IP assignment etc.Switch to the advance networking workflow.This is very important step, make sure you choose: I have uploaded in to a catalog, Select from Catalog and Click on Create vAPP. Review and finish, This will deploy the OpenVPN appliance, once deployed power on the appliance.